產品詳情
簡單介紹：
美國力科 lecory 1 GHz 有源差分探頭 1 GHz 有源差分探頭AP034
詳情介紹：
? 1 GHz Bandwidth
? x1 Gain
? ÷10 and ÷20 External Attenuators
? 10,000: 1 DC CMRR
? Low 35 nV/÷Hz Noise
? 1.5 pF/Side Input C
? 2 mV/div - 2 V/div
? Input Protection
Autobalance Feature
The AP034 is a high-performance active differential probe. High bandwidth, excellent common-mode rejection ratio, (CMRR) and low noise make the AP034 ideal for applications such as disk drive design and failure analysis, as well as wireless and data communication design.
Fully Integrated: With the ProBus® interface, the AP034 probe becomes an integral part of the oscilloscope. The probe sensitivity and offset can be controlled from the oscilloscope front panel, the probe front panel, or by using remote control commands (GPIB or RS-232).
Sensitivity, offset, input capacitance, and common-mode voltage range are displayed on the oscilloscope screen. When used with a LeCroy digital oscilloscope, no external power supply is required.
Wide Dynamic Range: The AP034 probe provides a range of sensitivities from x1 gain to ÷10 and ÷20 attenuation (with plug-on attenuators) for diverse signals. The sensitivity can be adjusted continuously from 2 mV/div to 2 V/div (2 V/div is achieved with plug-on attenuator) when used with a LeCroy oscilloscope.
DC CMRR is greater than 10,000:1 (80 dB).
OFFSET up/down buttons allow OFFSET control from the probe amplifier body. Momentarily holding down both buttons will zero the OFFSET.
A supplied AC coupling capacitor head (0.1 mF) allows operation with large common- mode or differential DC inputs.
Autobalance
Holding both offset buttons down for two seconds with the input connections removed invokes Autobalance. This provides the highest accuracy on all ranges by removing residual DC offset from the probe.
Low Noise
At full gain, the noise is less than 35 nV/÷Hz, allowing direct measurement of low-amplitude and high-bandwidth signals.
Input Characteristics
The input capacitance is modeled by 1.5 pF to ground from each input, plus 0.10 pF from input to input. This is equivalent to 0.9 pF differential input capacitance. Input resistance is 1 MOhm, including the accessory plug-on attenuator head. An AC coupling plug-on accessory features a 0.1 mF coupling capacitor for each input. Low-frequency CMRR is reduced when using this accessory.
Use with other Instruments
Instruments with 50 Ohm inputs, such as spectrum and network analyzers, time interval analyzers, and others, pose a challenge when the signal to be measured is differential or high-impedance. Low noise, high-bandwidth, and clean phase response make the AP034 probe an ideal signal conditioner to solve these problems. The optional ADPPS Power Supply provides power to the AP034 and converts the output to a conventional male BNC connector.
| 產品實圖 |
|
|
|